ok someone help me for hopefully the last time

[jasonlee 10+ year member]

I have these subs http://www.crutchfield.com/S-GokuoYyyRCo/cgi-bin/ProdView.asp?g=520&I=236T4510

and a hifonics taurus x amp which says 1 ohm stable stereo, 2ohm stable mono, 4x50w @ 4 ohms, 2x160@4ohms bridged

I dont know how to wire it to the subs.im only hooking up the 2 subs. i dont understand all of that ohms and stuff and the diagram that comes with the subs. I would appreciate the help

Click to read more...

 

[GFiess1187 10+ year member]

Can't get no simplier than that

 

[supraman1379 10+ year member]

Look at the diagram that sposted. Ill try to make it easy by saying it. That way you can look and read it to yerself.

Just start from the amp. Then go to the first set of VCs on the first sub. Run wires from that same VC to the VC on the other sub. And thats it

 

[jasonlee 10+ year member]

the amp is four channels.so i only have the 1 neg and 1 pos coming rom the amp into the first sub then another pos and neg wire going from that sub to the next one?sorry im new to this but thanx for helping

 

[jasonlee 10+ year member]

so i will only be using 1 channel? does it matter what channel i put the pos and the neg .ima little confused please help i dont wanna screw nothing up

 

[chevy_man 10+ year member]

Wire one sub bridged to the front channels, and one bridged to the rear channels. This should put you at 4ohms on each connection.

There should be a diagram on the amp or in the instructions telling you what connections to use to bridge the channels.

When you get it hooked up, PM me and tell me how it sounds. I have 2 of those subs sitting in a sealed truck box 2 ft. away from me at .62 ft3 waiting to go into my sisters truck, waiting on the amp to arrive.