Ok, how well would this 2 amp 2 sub set up work

[Afboy143 10+ year member]

Ok i have 2 4 ohm subs and 2 500 watt mono block amps.

Now what if i did this

I wired the subs like i would with just one mono block amp into 2 ohms. Now i would wire another amp connecting to where the first sub connected to. Would this work well or what? Please help. A pic i made below trys to explain it

Click to read more...

 

[junocdx 10+ year member]

I really dont think you should do that. What kind of amps are they? If they are stackable (has an RCA input AND output) I'd recommend wiring one sub per amp. Run your RCAs to one amp, then from the RCA OUTS on that amp to the other one. That way you have the full amount from each amp pushing each sub. You'll probably want a distrobution block for your ground and power though.

 

[paikiah 5,000+ posts]

even if they were the identical amps, if they are not stackable, I don'tthink you should do it...

 

[MikeofTulsa Moderator]

wouldnt do it unless both amps gain are set exactly the same and they are the same amp.....

 

[Afboy143 10+ year member]

Now what exactly is the difference between running like 3 power wires to the back VS. a dist. block?

 

[MikeofTulsa Moderator]

u could run 3 wires if u wanted to....however a distrobution block makes it much easier.....