ohm load help on FI btl fully loaded 18's

i no how to use the **** i just wanted help on what to tune the amps to an a box i allready got it all thanks everyone an pepole bein idot's on here sayin ill believe it when i see it an way to buy stuff an dont no how to use it ha ha i have installed many systems an have had some im goin all out with this one though so w.e u 2 can think what u want an ill get my **** an make hit harder the yours an well see what u say then

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Hello I'm happy to have came across this forum as I'm hoping someone will help with this little bit of confusion I'm having and maybe save me some...
0
1K
Hell... Run It.. You will be ok @ that Ohm load(2.67). Just dont go below 2ohms and you will be fine. 2ohms is the lowest stability of that...
5
1K
It also lowers the amps efficiency and raises the current draw.
5
465
What is the impedance of each set of terminals,assuming they represent each of the two dual voice coil subs (4 coils total)? How many sets of +/-...
2
303
Not all chargers are the same and charge and different rates. Any battery will deplete in that type of weather if you do not crank the vehicle for...
10
998

About this thread

ficaraudio789

Registered User
Thread starter
ficaraudio789
Joined
Location
cleveland ohio
Start date
Participants
Who Replied
Replies
16
Views
1,042
Last reply date
Last reply from
ficaraudio789
Screenshot_20240518-030709~2.png

1aespinoza

    May 18, 2024
  • 0
  • 0
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top