Offloading port on wall quick q?

  • 2
    Participant count
  • Participant list
General rule is you should allow at least a port width between port and wall. I've seen ppl get away with less, and need more. Some experimentation will be necessary to optimize.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yeah, saw that too, was like ??? wtf! They do know there stuff, I usually just roll with it!
13
1K
You could try to make the port longer, but there might be other reasons with the box won't extend lower, or even the sub. You'd have to reverse...
3
875
While that program is pretty neat, it assumes you know the values. I was just recapping the numbers you provided. RS recommends the following...
4
1K
Whoa, that will be one skinny port. The width of the back wall ports will be 1.08" wide (27.5mm), but the front port will be shared by 2 subs so...
5
1K
Yup. That is the bread truck that Richard Clark built for MTX many years ago . 60 inch subwoofer. The problem was that the truck wasn’t...
14
2K

About this thread

Lowflyin

10+ year member
Sit on my face, B*tch
Thread starter
Lowflyin
Joined
Location
FU JOSE, PA
Start date
Participants
Who Replied
Replies
1
Views
389
Last reply date
Last reply from
hispls
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top