New amp not working

[crash9201 10+ year member]

i just bought a power acoustiks 1200db mono, to power my two 10l74ohm, i upgraded my power and ground wire to 4 guage instead of 8 and hooked up the subs according to the top diagram here http://www.mp3car.com/vbulletin/attachments/car-audio/49102d1208280433-wiring-two-dual-voice-coil-subs-one-mono-amp-snap.gif. i know there are various different ways of wiring these up i know it verywell could just be that the imp is to high but i wanna double check b4 i go thru the proccess of pulling the subs out and wiring them a different.

the amp turns on, the subs tap when the volume is REALLY low, like at 5, but if i go anyhigher they stop hitting but the amp doesnt go into protect, it stays on and should be fine.

my electrical is all stock, it should still make the subs pound, or so i thought

EDIT

I just realized that i had bought an unbridgable mono amp and hooked up 2 subs to it.... any otherway i can wire these

Click to read more...

 

[!DeafImThinkI]

yea, search for some wiring pics. Im sure you can cook something up

 

[crash9201 10+ year member]

but it more than likely that its the imp. i just want to make sure i didnt a fried amp or sub....