Need answers quick!!!!!!

[yroc434]

no i havent touched anything

 

---------- Post added at 07:20 PM ---------- Previous post was at 07:19 PM ----------

 

im currenly at work but i can load pics later when i get off

 

[I'mPoor:(]

no i havent touched anything 

---------- Post added at 07:20 PM ---------- Previous post was at 07:19 PM ----------

 

im currenly at work but i can load pics later when i get off

Did you not listen to the system after the guy installed it for you? Did you not tell him it sounded bad?

 

[yroc434]

I was actually at work im gonna take everything out tomorrow and take it Crutchfield

 

[I'mPoor:(]

I was actually at work im gonna take everything out tomorrow and take it Crutchfield

If you settle down a little bit, and go step by step with us, we should be able to walk you through and troubleshoot to solve your problem without going through all that hassle.

 

[yroc434]

Ok..... Im in my car looking at the amp now and the settings are as follows

LPF about 100hz, SSFabout 25hz, Bass EQ zero degrees, phase zero degrees, level at about 10oclock with 9v being to your far left and 0.2v to your far right

 

[whitedragon551 5,000+ posts]

Ok..... Im in my car looking at the amp now and the settings are as follows
LPF about 100hz, SSFabout 25hz, Bass EQ zero degrees, phase zero degrees, level at about 10oclock with 9v being to your far left and 0.2v to your far right

Can tell you right now your LPF is set far to high and your gain is also set way to high.

Before you touch the dials do you have a multi meter? You should check the load from the sub box to make sure its wired properly before adjusting gains.

 

[yroc434]

Yes i have one on hand.... Give me 5mins to run grab it

 

[yroc434]

Ok subs are reading 1.9-2.1ohms

 

[blazian87 10+ year member]

Ok subs are reading 1.9-2.1ohms

Ok that's good. Now you need to use the DMM to calculate where your gains need to be.

Check out this simple tutorial video on how to set it up properly. Use a 50 hz tone.



After that's done, start your LPF at 80 hz and go from there.