Need a basket and cone for this....

[soloXgt 10+ year member]

What I have here is motor from a prototype from Protech. Lookin to get what the title states, but not 100% sure what basket/cone would fit it. Needs a 3" coil. (Inner diameter of vent pole is 2.9", and outer diameter before it hits magnet is 3.33") Six bolt pattern each spaced 2.5" between each bolt center to center. Motor is also XBL^2 and was built by adire. (don't know if it makes a diff.) if you need anymore information, let me know. I you have any ideas on what basket/cone would fit this, im up for anything. Wouldn't mind opinions on 10, 12, or 15". (I know there is still VC in there, I still gota clean it out.)

Click to read more...

 

[grimreper912003 5,000+ posts]

scott at fi could probably help you on this one. Or TC sounds might be able to recone it

 

[dalucifer 10+ year member]

looks like there is some left over coil in the motor still

 

[soloXgt 10+ year member]

anyone other than Fi?

 

[lilmaniac2 5,000+ posts]

i have a basket that will fit it i think, has the same spacer as some of my old dd's

 

[GSRswapandslow 10+ year member]

um.... http://www.protechloudspeakers.com/

maybe try them? lol

 

[GSRswapandslow 10+ year member]

http://www.protechloudspeakers.com/matrixseries.htm

those look nice....why not just go back similar?

 

[soloXgt 10+ year member]

guy I got his from is a rep for protech. I talked to some people and said he couldn't find/get anything because it was a prototype. only a few were made (less than 5) and the others are gone, or shot

from protech website.........

"Matrix Sub project delayed...

Due to unforeseen delays and constant setbacks we regret to say that the MartiX super-sub project has been put on long-term hold. Please refer to this page for updates regarding this matter. "

no way i can get parts through them