Just Need to Check

[gabe8501 10+ year member]

I want to make sure I wired my subs the correct way. I have two Diamond D6 12s, DVC 4OHM. I want to run them at 1 ohm.

Here we go, I ran the speaker wire out of my amp and then spliced it from one + and one - to two +'s and two -'s. Then I rean one set of +&- to one sub and the other set to the other sub. And finally wired the +'s on the subs together and the -'s on the subs togehter. Is that yielding a 1 ohm load??

I know, I know..... crutchfield and sounddomain have guides. I just wanted to make sure my dumb *** didn't screw anything up when I spliced the speaker wire.

Any info would be greatly appreciated. Thanks

Click to read more...

 

[skadude016 5,000+ posts]

does it look like this?

 

[gabe8501 10+ year member]

does it look like this?

Sure does. Except it's not really one run of speaker wire from the amp.... I kinda used existing speaker wire on the subs and then just crimped the fuggers with the speaker wire coming from the amp.

 

[skadude016 5,000+ posts]

as long as you have all your +'s hooked up and going to the amp

and all your -'s hooked up to eachother you should be fine