Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Just Need to Check
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="gabe8501" data-source="post: 1730647" data-attributes="member: 566203"><p>I want to make sure I wired my subs the correct way. I have two Diamond D6 12s, DVC 4OHM. I want to run them at 1 ohm.</p><p></p><p>Here we go, I ran the speaker wire out of my amp and then spliced it from one + and one - to two +'s and two -'s. Then I rean one set of +&amp;- to one sub and the other set to the other sub. And finally wired the +'s on the subs together and the -'s on the subs togehter. Is that yielding a 1 ohm load??</p><p></p><p>I know, I know..... crutchfield and sounddomain have guides. I just wanted to make sure my dumb *** didn't screw anything up when I spliced the speaker wire.</p><p></p><p>Any info would be greatly appreciated. Thanks</p></blockquote><p></p>
[QUOTE="gabe8501, post: 1730647, member: 566203"] I want to make sure I wired my subs the correct way. I have two Diamond D6 12s, DVC 4OHM. I want to run them at 1 ohm. Here we go, I ran the speaker wire out of my amp and then spliced it from one + and one - to two +'s and two -'s. Then I rean one set of +&- to one sub and the other set to the other sub. And finally wired the +'s on the subs together and the -'s on the subs togehter. Is that yielding a 1 ohm load?? I know, I know..... crutchfield and sounddomain have guides. I just wanted to make sure my dumb *** didn't screw anything up when I spliced the speaker wire. Any info would be greatly appreciated. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Just Need to Check
Top
Menu
What's new
Forum list
