Installed and ran into some problems

[outspoken 10+ year member]

2 svc 4 ohm woofers should be + to + to + on amp, - to - to - on amp... this will give you a 2 ohm load...

 

[Asian Invasian 10+ year member]

they shaould be wired like this first diagram...http://www.rockfordfosgate.com/rftech/woofer_wizard.asp?submitted=true&woofer_qty=2&woofer_imp=1

other than that idk... i've never used an loc. does it have a level knob on it? the loc i mean

oh snap so the positives of both speakers should be set together???!!

 

[dman4486 5,000+ posts]

those subs are 300w rms...you are putting in 150w rms

 

[dman4486 5,000+ posts]

oh snap so the positives of both speakers should be set together???!!

IT IS A MONOBLOCK...IT DOES NOT MATTER

 

[outspoken 10+ year member]

oh snap so the positives of both speakers should be set together???!!

yes, if the link is correct they are "single voice coil" subs... you are presenting a 8 ohm load to the amp instead of 2...

 

[dman4486 5,000+ posts]

yes, if the link is correct they are "single voice coil" subs... you are presenting a 8 ohm load to the amp instead of 2...

wrong...

 

[outspoken 10+ year member]

wrong...

this is incorrect?

http://www.rockfordfosgate.com/rftech/woofer_wizard.asp?submitted=true&woofer_qty=2&woofer_imp=1

 

[Asian Invasian 10+ year member]

here is what I did...

 

[dman4486 5,000+ posts]

my point is that his amp is a monoblock...w/ a monoblock and 2 subs you wire each sub to it's own set of terminals...

the amp itself places the coils in parallel....

you actually can do it that way, but if you have the 2 sets of connections, then use them

 

[outspoken 10+ year member]

here is what I did...

noooooo... follow the link i posted...

 

[dman4486 5,000+ posts]

here is what I did...

that is how it should be...creating a 2ohm load

 

[dman4486 5,000+ posts]

noooooo... follow the link i posted...

you do not understand what a monoblock does

 

[Asian Invasian 10+ year member]

noooooo... follow the link i posted...

your both telling me different things, did I wire this wrong? This is what I had before I have not went out to the car to switch anything.

 

[outspoken 10+ year member]

you do not understand what a monoblock does

did you look at the amp he posted?

 

[Asian Invasian 10+ year member]

that is how it should be...creating a 2ohm load

ok well that is what i did and I had the problem...