i need box plans made for my 9510

[bobtista 10+ year member]

http://www.ddaudio.com/dd/caraudio/woofers.asp?series=9500g

Thats the link to the sub on DD's page. I want this between 35 and 40hertz. If you can make the plan just give me a price for it and i can pay you. its only one driver.

Click to read more...

 

[Louisiana_CRX 5,000+ posts]

which series 9510?

 

[brtnboarder3241 5,000+ posts]

g?

 

[Louisiana_CRX 5,000+ posts]

Do a 1.5 cu ft box plus port....make port 24sq inch opening...by 16" long ...it will make you happy //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[hrtbrk1 5,000+ posts]

hey dave...what tuning to u use for all ure 9500g series?

 

[Louisiana_CRX 5,000+ posts]

40hz

 

[Louisiana_CRX 5,000+ posts]

with a 10 you don't really want to drop it much lower due to cone area....but it would probally work fine if tuned lower....

 

[bobtista 10+ year member]

its a g. so i should deff. tune to 40hz?

i figured that would give me the best output with how DD stuff is made. i have my 10" BL tuned to 32hz, and it sounds amazing, so I had to ask.

 

[hrtbrk1 5,000+ posts]

40 hz...ok kool..im guessing u tried a lot of different freq...but was happy with that yeah?

 

[Louisiana_CRX 5,000+ posts]

I run my 8's at 40 also...They don't really like anything below 40

 

[psych0ticnemes1 5,000+ posts]

You have a PM in case you still need a design.

 

[Louisiana_CRX 5,000+ posts]

its a g. so i should deff. tune to 40hz?
i figured that would give me the best output with how DD stuff is made. i have my 10" BL tuned to 32hz, and it sounds amazing, so I had to ask.

Try it in the BL box if your not using it....It won't hurt...try to listen for any bottoming....though....You may have to trim the hole about a jigsaw blade around for the G basket to fit

 

[bobtista 10+ year member]

cool. thanks. i was also wandering what would be the safest daily rms to run to on 10" 9500g?

right now I am going to be running it with my lanzar opti2000D at 1ohm. I think its CEA rated to put out 1700watts at 1ohm. I plan on doing all DD throughout (that is once DD puts out their '08 comp and coax)and i need to either get the M1a or M3. I was planning on the M3 but i need to know if it will destroy the sub or if i should just get another driver. or if the m1a will push the single 10" fully.

 

[Louisiana_CRX 5,000+ posts]

i've been running M3's on single 3510's with no probs...old series an new...i just don't let my signal clip....the 9510g can take a M3 with ease...those are good amps.....

 

[bobtista 10+ year member]

great news. thanks.