help to wire my system

jojo1212
10+ year member

Junior Member
sup guys ?

so my system is ready

got 2 amps

1- rockford P600.1bd

http://www.rockfordfosgate.com/products/product_details.asp?cat_id=2&series_id=6&family_id=19&item_id=106477&locale=en_US&p_status=

2- rockford punch45

http://www.rockfordfosgate.com/products/product_details.asp?cat_id=2&series_id=8&family_id=26&item_id=100035&locale=en_US

----------------------------------------------------

rockford T162s component speaker for the front

http://www.rockfordfosgate.com/products/product_details.asp?cat_id=3&series_id=34&family_id=29&item_id=91973&locale=en_US&p_status=

-----------------------------------------------------

rockford P1692S component speakers for rear fill

http://www.rockfordfosgate.com/products/product_details.asp?cat_id=3&series_id=33&family_id=28&item_id=91967&locale=en_US&p_status=

-----------------------------------------------------

2 JBL GTO 1204D subwoofers

http://www.jbl.com/car/products/product_detail.aspx?prod=GTO1204D&Language=ENG&Country=US&Region=USA&cat=SUB&ser=GTS

-----

everything is installed

i just need you guys to advice me in wiring the speakers and the subs to the amps

best wiring options

thnx yall in advance

 
Rockfords website should have all the info you need as far as diagrams. If you need to know how/ where to run wires through the car, start reading as there is lots of info here. You subs are dual voice coil so you should hook them up for a 2 ohm load to your amp. If you have any doubts, pay someone to do it for you. Thats all the help I can give, being a newbie my self. Good luck.

 
youd probably be better off to get it professionaly installed cuz if u mess up well your screwed, at least u can go back to the professional and get him to help out. hopefully you have a warranty if you do it yourself.

 
just a 2 guage for the amp and for the subs used a 8 guage wires....ground and power wires has the be same guages to be putting out enough and the same amount of powers so thats why use a bigger wire...2 guage is big enough...

 
ok thnx yall

my amps are already installed and wired

my question was to which amp i should connect the front speaker

to which amp the rear speakers

since i dont know alot about watts and wrms

i dont wanna connect some speakers to a powerful amp which could destroy them

for my subs i wannt to connect them to the p600.1bd amp

but rockford site states that the amp can push 600W x 1 @ 2-Ohms RMS

so will this jbl sub (only 300 rms) take that load of power when wired at 2ohm

and when both of the subs are wired like this to the amp

http://www.jbl.com/car/product_support/SubwooferWiring/sub_wiring_diagram.aspx?type=2-4-4

i still have one channel left on the amp, so can i use the other one for other subs

or speakers ??

i want the best wiring option for my subs

 
If you have two 4 ohm subs then you should wire them in parallel to present a 2 ohm load to the amp. That's probably how the amp is wired internally (that's why there are two positive and two negative terminals), but read the manual to find out for sure. If it isn't, you can read the manual to find out which one positive terminal and one negative terminal you should use and just wire the subs in parallel before the amp.

You have a 2 channel amp for your front stage, so you can run the fronts (as long as you have passive crossovers) off of the amp and the rear fill off of the HU.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

jojo1212

10+ year member
Junior Member
Thread starter
jojo1212
Joined
Location
ummm
Start date
Participants
Who Replied
Replies
9
Views
771
Last reply date
Last reply from
jojo1212
561786595_18427607485102160_7010259965928918509_n.jpg

just call me KeV

    Oct 9, 2025
  • 0
  • 0
561583216_18427455586102160_8141545757991593433_n.jpg

just call me KeV

    Oct 9, 2025
  • 0
  • 0

New threads

Top