First build completed. Pics and video included.

K_Watson
10+ year member

Member
I have completed my first build and I stayed just about in the budget I had planned, and got just the right amount of sound I was looking for.

1998 Chevrolet Prizm

Aiwa CDC-X217 Headunit (Because I like it.)

4 x Pioneer 6.5" 2-way speakers 30w RMS (powered ~20w RMS off headunit)

2 x MTX Thunder 5000's in sealed enclosure 4ohm 250w RMS each, wired parallel for 2ohm

1 x Alpine MRP-M500 Monoblock Amp 500w RMS @ 2ohm

Wired with 8 guage for power, fused at 60 amps, 12 guage to subs, cut-off switch on remote wire for amp disable

Headunit: $35

Speakers: $90

Amplifier: $150

Subs: FREE

Wires, Misc: $60

I know it's not a high-end setup, but it's just right for now.

Video...



Pics...

Headunit

img20110409191140.jpg


Wiring

img20110414154304.jpg


Wiring hidden

img20110414154430.jpg


Subs and amp below...

 
Last edited by a moderator:
good ****, though 150 is spensive for a 500watts amp on a budget build
I bought the amp for now and the future. Later I plan on getting a small hatch/wagon and I will tuck a 10 or 12 inch sub in a small box.

Edit: Plus the free subs left me some extra $ to get the nice amp.

 
were do you work? how many of these do you have left?
AutoZ0ne. They're clearanced for ~$55, then I used my discount.

Most stores carry a variety of units from either Dual or Kenwood, or both, and some don't. Only the Kenwood's are on clearance.

What my store had...

kdc-mp138 $45

Kdc-mp245 $55 (sold out)

Kdc-mp342u $69 (sold out)

Kdc-mp138 w/ speakers $54

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Well, I've owned probably over 100 different drivers in the last 40 years and almost every single speaker in the NVX line-up over the last 8...
16
952
https://www.youtube.com/@therealmatty_s/videos
0
517
I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
I got to message a DD woofer builder a decent bit my last stent of box designing; they would send me designs to do for or with individual...
5
883
Currently Audison amps 500.1 and 4.300 with kappa 90csx 6x9 component set. Pair of morel 6.5 rear and a single 10” alpine type R.
7
954

About this thread

K_Watson

10+ year member
Member
Thread starter
K_Watson
Joined
Location
Indianapolis, IN
Start date
Participants
Who Replied
Replies
10
Views
1,584
Last reply date
Last reply from
K_Watson
20240519_201349.jpg

Mr FaceCaser

    May 19, 2024
  • 0
  • 0
20240519_201344.jpg

Mr FaceCaser

    May 19, 2024
  • 0
  • 0

New threads

Top