Creating a **** effect for L7 box.

[Chevyaudio 5,000+ posts]

Yeah...that didnt turn good.

 

[Dtrickz 10+ year member]

yea ur gonna have to paint it with some auto paint to get a good finish...spray paint imo almost always looks like shit. i dont think the bondo will crack cause we use alot of bondo on plastic bumpers and what not which bend and it usually does ok.. i would of just used some fibergel to build it up first and make it quicker. I hope your not sanding that all by hand? I would of had to use a da with all that sanding

 

[Army-Killa]

the bondo doesnt look like its taking that paint all to well.

 

[Lorinser430 10+ year member]

A few things:

1. Your Bondo is going to crack

2. Bondo is a filler, not a structure builder

3. You fill those pits with putty, not more bondo.

4. Your bondo is going to crack

5. You need to be sanding with a block, not your hand.

6. See five to remove the waves in the bondo.

7. You don't sand after every layer of paint..

8. Use shop-vac to remove plaster from carpet when it falls off your box.

...other than those few things, it looks great!! Keep up the good work! //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[orphe 10+ year member]

A few things:
1. Your Bondo is going to crack

2. Bondo is a filler, not a structure builder

3. You fill those pits with putty, not more bondo.

4. Your bondo is going to crack

5. You need to be sanding with a block, not your hand.

6. See five to remove the waves in the bondo.

7. You don't sand after every layer of paint..

8. Use shop-vac to remove plaster from carpet when it falls off your box.

...other than those few things, it looks great!! Keep up the good work! //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

its finished and so far, so cracks:veryhapp:

only problem is the L7 on the right is making weird sounds(I think its blown) and I might need to take it out.

 

[BASSMEKANIK 10+ year member]

only problem is the L7 on the right is making weird sounds(I think its blown) and I might need to take it out.

typical L7's //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[bballrrt06 10+ year member]

its finished and so far, so cracks:veryhapp:

only problem is the L7 on the right is making weird sounds(I think its blown) and I might need to take it out.

while it doesn't look bad, that seems like a shi!t load of work for very little result. but hey props on the effort.

 

[kpozr2 10+ year member]

check to see if any of your screws are loose, thought one of mind had something wrong with it, just turned out a screw was loose making the noise.