Hi,
I am trying to setup the new Full Digital System from Clarion (Z3 tweeters, Z7 mids for front and rear doors, and dual Z25W subs.
This system is unique in that it processes the digital signal and sends it to the speakers in 1s and 0s. From there, the speaker processes that into cone movement. This eliminates the need for big amplifiers while eliminating electrical interference.
So, I'm trying to set my active crossovers for this, but because it is still so new, there isn't a lot of help online. Here is what I'm working with and what my original settings are. Any help would be greatly appreciated!
Z3 tweeters:
6ohm
1.5kHz ~ 40kHz
Z7 mids:
Driving section:
89dB at 1W S/N
102dB Dynamic Range
10Hz ~ 48kHz +/- 2dB Freq Response
Speaker section:
4ohm
28Hz ~ 15kHz
60Hz Fs
0.85 Qts
Z25W subs:
Driving section:
90dB at 1W S/N
103 dB Dynamic Range
10Hz ~ 48kHz +/- 2dB
Speaker section:
4ohm
20Hz ~ 200Hz Frequency Response
38Hz Fs
4.75 Qms
And this is what I have so far. Any advice on how to dial this in?
Tweeters:
HPF = 3.15kHz
Slope = -24
Gain =-9.0
Phase = Normal
Mids:
HPF = 80Hz
Slope = -24
LPF = 2.5kHz
Slope = -18
Gain = 0
Phase = REV
Subs:
HPF = 20Hz
Slope = -12
LPF = 80Hz
Slope = -12
Gain = 0
Phase = Normal
I am trying to setup the new Full Digital System from Clarion (Z3 tweeters, Z7 mids for front and rear doors, and dual Z25W subs.
This system is unique in that it processes the digital signal and sends it to the speakers in 1s and 0s. From there, the speaker processes that into cone movement. This eliminates the need for big amplifiers while eliminating electrical interference.
So, I'm trying to set my active crossovers for this, but because it is still so new, there isn't a lot of help online. Here is what I'm working with and what my original settings are. Any help would be greatly appreciated!
Z3 tweeters:
6ohm
1.5kHz ~ 40kHz
Z7 mids:
Driving section:
89dB at 1W S/N
102dB Dynamic Range
10Hz ~ 48kHz +/- 2dB Freq Response
Speaker section:
4ohm
28Hz ~ 15kHz
60Hz Fs
0.85 Qts
Z25W subs:
Driving section:
90dB at 1W S/N
103 dB Dynamic Range
10Hz ~ 48kHz +/- 2dB
Speaker section:
4ohm
20Hz ~ 200Hz Frequency Response
38Hz Fs
4.75 Qms
And this is what I have so far. Any advice on how to dial this in?
Tweeters:
HPF = 3.15kHz
Slope = -24
Gain =-9.0
Phase = Normal
Mids:
HPF = 80Hz
Slope = -24
LPF = 2.5kHz
Slope = -18
Gain = 0
Phase = REV
Subs:
HPF = 20Hz
Slope = -12
LPF = 80Hz
Slope = -12
Gain = 0
Phase = Normal