Building a sub....

[Grinder1989 5,000+ posts]

another pic.

 

[02parkave 5,000+ posts]

Park is the motor man...
Park, are you planning to start a motor museum or what?

well.. i got at least 2 more 4hp's coming (maybe 4) and i am going to make 6-8 more 4hpz's... //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif now.. hows my box of stuff coming Mark?

 

[mrogowski 5,000+ posts]

Its not. //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

I'll take the time tomorrow to get it together for ya.

 

[02parkave 5,000+ posts]

dam.n you!!!LOL- whenever... im not in any rush...

no really. get to work.

 

[Grinder1989 5,000+ posts]

Well can anyone give me some advice on how I should build up the sub?

 

[Blove1991 10+ year member]

I wish I could have the supplies and knowledge to build me a sub

 

[02parkave 5,000+ posts]

Well can anyone give me some advice on how I should build up the sub?

what do you want to know? easiest way is probably to send it off to somewhere (team psi, FI, etc)... unless you know where to get the coils,spiders,cones, etc.. in quantities of 1?

 

[Grinder1989 5,000+ posts]

I'm going to get a re-cone kit from FI but I don't know whether or not I want it to be an 18 or a 15. And I don't know how to change the specs on the sub with soft parts.....

 

[02parkave 5,000+ posts]

are you sending them the sub or are they sending you the kit? if they are sending you the kit im sure they will need the coil measurments and the like...

 

[Grinder1989 5,000+ posts]

I'm not sure yet...That motor is heavy and I don't want it busted....I might jsut have them send me a kit.

 

[02parkave 5,000+ posts]

do you have the original coil? or anything like that? they will need the gap measurements I'm sure...

 

[Grinder1989 5,000+ posts]

Nope, Just a motor it takes a 3 inch coil.

 

[02parkave 5,000+ posts]

I know that.. but 3" coil isn't universal... coil measurements go to the thousandth.. I would imagine they would need the ID and OD of the coil.. a typical coil measurement looks like this (at least with who i get my coils from)-

3.902ID 4.234OD 2.300WW 5.5FH

ID=inner diameter, OD=outer diameter, WW=Winding Width, FH= Former height...

If you can give them the gap measurements they can get you up and going, I'm sure!

 

[Grinder1989 5,000+ posts]

ah i c......Well I could figure that out. somehow.

 

[02parkave 5,000+ posts]

good luck!