Amp problem

  • 1
    Participant count
  • Participant list

always6z

CarAudio.com Newbie
i have a crunch powerzone pz1500.1 it only works with it turned all the way down when i turn it up it emits a very loud humming noise not like the regular hum u are thinkin about this isnt engine noise its a full blast loud hum when u turn the amp down it cuts completely off at about 10% how do i fix this and if its the amp is it worth fixing thanks
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Using a Y RCA to split signal from amp to amp to give both amps the signal they need from the HU and subs in different /separate enclosures tuned...
3
564
Fully test it without the ACR-1. TBH it sounds like an amplifier issue. Try connecting your phone direct to the amp via a 3.5mm to RCA cable. If...
2
668
If a sub's voicecoil fails, it will usually drop impedance causing too much current to go back to the amplifier. The amplifier then protects...
15
2K
Have you checked the fuse block. With time, tight connections can loosen and cause failure. Refresh those contact points and test again. Remember...
1
1K
Amp
https://stingeroffroad.com/products/2000-watt-monoblock-car-amplifier-mt-2000 These are $199 and you can get an additional 10% by signing up your...
2
38

About this thread

always6z

CarAudio.com Newbie
Thread starter
always6z
Joined
Location
Terre haute
Start date
Participants
Who Replied
Replies
0
Views
353
Last reply date
Last reply from
always6z
IMG_6578.png

saints747

    May 7, 2024
  • 0
  • 0
IMG_6579.png

saints747

    May 7, 2024
  • 0
  • 0

Latest topics

Top