ALL DONE install (almost)

[cbuts 10+ year member]

ill show you what i did

 

[cbuts 10+ year member]

[quote name='E-Rock']@cbuts

I got the passenger door all done. I still can't figure out the driver's side though. I'm fishing around near the parking brake and can't find where the interior grommet is.

One problem with the passenger side though, when feeding wire through the passenger jamb, a tiny black wire looks like it broke off, I'm guessing it goes to the window or door lock. Fvck...[/QUOTE]

install :: IMG_1506.jpg picture by cbuts05 - Photobucket


install pictures by cbuts05 - Photobucket


was my dads idea, we just popped it out enough and drilled a hole on the inside of the car, fed it up the hole with a hanger to the grommet, and pulled it through the door, and the grommet popped back on easy(although its a slight pinch to the wire) its fine though.

trust me it is a real pain in the *** getting the wire through, my dad seemeed to have not much of a problem though. u may have to take the panel along the side of the car near the door, its REALLY hard to feel the grommet in my car, i had to like wedge my hand in there

 

[cbuts 10+ year member]

@E\-Rock howd it go?

 

[E-Rock 10+ year member]

Pretty much all done. I need to move my crossover on my drivers side over because it's a tight fit when putting the panel back on. I was able to feed the wires through but not through the plastic grommet, I kinda of half-assed it by placing it along the metal part the plastic part clips on to. So I need to do a few mods on that.

My passenger door the window rubs on a wire or something on its way down.

Otherwise everything is good, I just need to tuck some wires. It's not too bad I need to take my door panels off again because I need to adjust my crossover's tweets to -3dB.