Reply to thread

Message: <blockquote data-quote="E-Rock" data-source="post: 7777057" data-attributes="member: 628334">Pretty much all done. I need to move my crossover on my drivers side over because it's a tight fit when putting the panel back on.  I was able to feed the wires through but not through the plastic grommet, I kinda of half-assed it by placing it along the metal part the plastic part clips on to. So I need to do a few mods on that.My passenger door the window rubs on a wire or something on its way down.Otherwise everything is good, I just need to tuck some wires.  It's not too bad I need to take my door panels off again because I need to adjust my crossover's tweets to -3dB.</blockquote>

Top