alarm install

[rfmayhem 10+ year member]

i have a clifford 590.2x and i have to addons which is the dual zone motion sensor 508d and digital tilt sensor 507m how do i wire these two to my alarm thur the optional mux port for additional sensors

Click to read more...

 

[keep_hope_alive Premium Member]

read the installation manual

 

[BS1D3 10+ year member]

508d requires its own power and ground, so just cut the black and red on the harness for the 508d, use your GWA for ground and just 12v for the red wire, the tilt sensor should be fine just plugging it in to the mux port.

 

[rfmayhem 10+ year member]

508d requires its own power and ground, so just cut the black and red on the harness for the 508d, use your GWA for ground and just 12v for the red wire, the tilt sensor should be fine just plugging it in to the mux port.

where do i wire the blue and green wire of the 508d

 

[BS1D3 10+ year member]

Oh yeah, forgot about those. Blue and Green will both go to the green wire on the mux port, I would diode isolate just in case. But I would definitely run ground to GWA (Ground when armed) it prevents false alerts.