Aftermarket CD Player with Factory Tape Deck

  • 3
    Participant count
  • Participant list
You should be able to add a cd changer without removing your factory stereo. This way you can play cds and tapes. I have an equalizer/preamp that has two inputs so you can switch between tape player and cd changer . I think you need to connect it to an amp though.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No way to tell if the wiring is bastardized without looking for yourself. Wiring adapters are cheap enough at installer.com. That said there is...
4
658
High pitch whine is usually a grounding or interference issue or from using inexpensive signals cables run parallel to power/ground lines. Or, as...
6
1K
So you have your main power wire which feed the current it needs. Your original HU would have had it, and you probably connected your new HU to...
2
765
Nice, well I think they will blow away anything you have running on your puter for sure. I've had good luck with the NVX components, hard to beat...
16
2K

About this thread

LAOPRINCE

Junior Member
Thread starter
LAOPRINCE
Joined
Location
Windsor, ON
Start date
Participants
Who Replied
Replies
5
Views
733
Last reply date
Last reply from
indosia
20240518_170822.jpg

Dylan27

    May 18, 2024
  • 0
  • 0
20240517_190901.jpg

Dylan27

    May 18, 2024
  • 0
  • 0

New threads

Top