fishytroll66
CarAudio.com Newbie
Hi all, I have a Kenwood headunit, the front and rear speakers are wired, not through RCA outs, I am adding an active underseat subwoofer. Can I use the RCA sub outs for the sub and leave the speakers wired?
advice please anyone?
- Thread starter fishytroll66
- Start date
- Replies 3
- Views 540
-
4Participant count
-
Participant list
marc2112 10+ year member
CarAudio.com Elite
Louisiana_CRX 5,000+ posts
dem shoes......
Yes ..that will work just fine .
Activity
No one is currently typing a reply...
Similar threads
If I'm picking up what your putting down. Your going to bridge one side for the sub and run the other side for the speakers. I would run one amp...
- Started by Ailas1951
- Wiring, Electrical & Installation
Ah excellent, I did have it as series to begin with but read on another forum to add both positive and both negatives in bridge. Thanks for the...
- Started by DjRedcap
- General Car Audio
Signal flow should be HU to DSP to amps. You would lose the ability to EQ and time align the sub with the DSP unit if you bypassed the DSP.
- Started by supafly1
- General Car Audio
The HU us likley 12-15 x 4 at best so yes, using an amp will be hugely beneficial, night and day. The HU us not going to drive a sub to any...
- Started by Paul Curtis
- General Car Audio
About this thread
Latest topics
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1
-
-
-
-
Help With Kenwood DDX9907XR / DMX907S - Kenwood Technical Support Can't Help
- Started by fadetoblack73
- Replies: 5