A girl doing a guys job...help! Amp not working and now stereo too!

How do i insert images 

---------- Post added at 12:48 AM ---------- Previous post was at 12:47 AM ----------

 

What
You send them to me and let me verify they are worthy then I post for you LOL.. IDK really sometimes it lets new people post pic/vids and sometimes it dont.. Use photobucket if u must.

 
 
from what i can see you cut the factory harness correct? other than that the sub should just plug and play unless its wired under 4 ohms. id double check the deck wiring and judging from the power and ground connections on the amp u might need a larger gauge wire at minimum 8 gauge

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It will probably change your tuning. I've seen bigger numbers off of much less power from walling at the rear seats, but Terry "trunk king" Brock...
1
935
Can anyone in here participate in a short interview I am doing for school about the installation of a Kenwood DMX4070S in my 2005 Ford Expedition...
0
976
Me too and then I have to paddle anywhere I want to go.
6
1K
Got everything installed and running. It's definitely dragging my idle down a bit, I may bump my idle speed up a few hundred Rpm until the voltage...
3
1K

About this thread

MSTBCRZY88

10+ year member
Junior Member
Thread starter
MSTBCRZY88
Joined
Location
SO CALIFORNIA
Start date
Participants
Who Replied
Replies
59
Views
7,022
Last reply date
Last reply from
Falcons
IMG_0632.jpg

just call me KeV

    Apr 19, 2024
  • 0
  • 0
IMG_0629.jpg

just call me KeV

    Apr 19, 2024
  • 0
  • 0

Latest topics

Top