4 DP21 4th Order Build

[rmzsuzuki89 10+ year member]

Specs for the DP 21 D2's I had (Pre-Break In)

Saved to hard drive lol, thanks...But why is the dia. 0.00?

 

[audio_phill 10+ year member]

Saved to hard drive lol, thanks...But why is the dia. 0.00?

EDIT: Misread Question.

I didn't put a diameter in because there was no need for it knowing Sd. Diameter was right around 18" though, prob +/- .125"

Reverse engineer the .164m2 to get it closer to exact lol.

 

[rmzsuzuki89 10+ year member]

EDIT: Misread Question.
I didn't put a diameter in because there was no need for it knowing Sd. Diameter was right around 18" though, prob +/- .125"

Reverse engineer the .164m2 to get it closer to exact lol.

O I see, thanks.

 

[O.G. D-Wet 10+ year member]

**** DPs. Wardens would have been KILLER! lol

 

[Mr. Slate 10+ year member]

That crimper is crazy!

 

[O.G. D-Wet 10+ year member]

That crimper is crazy!

x2!

 

[basebalz13 10+ year member]

**** DPs. Wardens would have been KILLER! lol

x2

 

[80INCHES 5,000+ posts]

hmm this build is very familar

80

 

[maritoze 10+ year member]

Since a couple of people wanted to see my crimpers, here they are.

Aren't these lovely? I found a pair on ebay brand new for 43 shipped.

 

[rmzsuzuki89 10+ year member]

hmm this build is very familar
80

It's pretty close to the guy with the Wardens. I was watching that build for a while. I kinda wanna try and find it again to see how it came out, or is coming along.

 

[rmzsuzuki89 10+ year member]

Just got done drilling all my holes and putting the grommets in.

There are just 8 of them here. I'll take pics of them all when I finish vacuuming all the metal shavings out.

 

[O.G. D-Wet 10+ year member]

Just got done drilling all my holes and putting the grommets in.
There are just 8 of them here. I'll take pics of them all when I finish vacuuming all the metal shavings out.

Maybe a magnet will help???

 

[rmzsuzuki89 10+ year member]

Maybe a magnet will help???

That worked to an extent. All the little ones that were in small spots didn't wanna come out.

 

[rmzsuzuki89 10+ year member]

Just finished up for today. Got all of the holes drilled and grommets in, and 3 more runs ran. So just 3 more runs to go, I'm running out of places to send the wire down to under the car lol.

Almost one spool gone, moving to the next spool.

Sending a run down.

How it looks up front as of now, quite messy right now lol.

 

[rmzsuzuki89 10+ year member]

Nice and neat haha.