2011 Sonata LOC Question

  • 2
    Participant count
  • Participant list

dacheatham
10+ year member

CarAudio.com Veteran
I have installed and uninstalled several systems in my car but in each scenario have used a processor(ms-8, 3sixty, audio control lc6i), all of which had summing.

I am getting ready to put an amp or two back in and wanted to see if anyone knew if all of the speaker outputs from the factory source are full range. Just checking to see if I need to invest in another professor or high end LOC for now or if I can grab a Navone unit. The car is an SE so no amplifiers I am aware of.

I will probably be doing am amplified front stage and sub stage, either a multichannel or two amps.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

These are also very good drivers, some of the best bang for the busk on shallow mounts. DD Audio SL610-D2 10"...
5
656
Probably the adapter brand. Other users have found that the pins do not coincide with the factory pinout guide. They have solved this by pulling...
1
894
HUGE thanks to everyone who contributed in here to helping me determine my amp was the issue. You guys were great. I now own a multimeter which...
53
6K
Hi crew! I’m reaching out for some help. I have a 2011 Fiesta SES and have all the parts needed for a conversion to Sync 3 except the harness...
0
1K

About this thread

dacheatham

10+ year member
CarAudio.com Veteran
Thread starter
dacheatham
Joined
Location
Russellville, Arkansas
Start date
Participants
Who Replied
Replies
1
Views
458
Last reply date
Last reply from
Wadester999
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top