2007 Tundra Crewmax with JBL / Nav

[lildev0426]

Hi folks. I really need to get the wiring info for the stereo / spks and including the JBL amp for my truck.

I am installing the following:

(keeping stock hu)

jl cleansweep

fronts - id ctx 6.5's

sub - jl 13tw5

rf t600.4

disconnect rear speaks, sub and jbl amp

i want to run the cleansweep to the t600.4 to the fronts in stereo at 4 ohm and bridged to the sub at 3 ohms. i was hoping to tie the cleansweep into the stock amp speaker inputs to avoid taking the stock hu out at all. i would disconnect the stock jbl amp all together. i was also going to use the amp turn -on lead to the cleansweep and use the cleansweep turnon lead to the t600.4.

does this sound like a legit plan or am i missing something that makes this not possible or feasible?

if i need to use the jl summing device with the Cleansweep -

how would i tap into and sum the signals? do i bring the amp outputs and or inputs into the ssi and then into the csweep? thanks again

Click to read more...