-
4Participant count
-
Participant list
-
JEFFakaMAX 10+ year member
Noise Complaint Recipient
I've never seen a 4/ch input on a Mono amp. The second set of RCA's are the pass through for daisy-chaining another amp.
sacsking916 5,000+ posts
stayin high an loud
for direct lead subwoofers iirc or something to do with briding the subs i know that
JEFFakaMAX 10+ year member
Noise Complaint Recipient
Oh, on the outputs. It is just for ease of wiring. Both + and both - are the same internally.
when a mono amp has 2 sets of +/- terminals that just means that they are paralleled internally. i.e. you hookup a dual 4 sub to it, where each coil is wired up to a set of terminals. thats 4 ohm per terminal, then paralleled internally for a 2 ohm load.
- Thread Starter
- #7
Exactly I figured it was more for coinveince as well, say if i guy wants to run multiple subs?
I see what your saying.. was really lost last time (the only time) we had to hook up my HDC3 which i ordered D2 but ended up with a D1.. we had wires going into all four outputs on my saz 1500.. now what would we have done if there would have been only 1 set of outputs?
Activity
No one is currently typing a reply...
Similar threads
Let us know how it turns out!
- Started by PatLap
- Wiring, Electrical & Installation 2
I get it. I'd never run a tone through at full tilt to test just how much they can take before it goes all willie nelson either 🤣
- Started by GoldCountryCA
- Amplifiers 3 4 5
I had two Skar amps (4ch & a monoblock) go bad within a year. Post #2 is an excellent recommendation.
- Started by KcContractor
- Amplifiers
Buy the 4 ch and keep the other. Usually on a 5 ch there isnt much of a substage, but there are a couple with a 1k @1ohm ch., but very few. A 5...
- Started by Adel
- Amplifiers
Mixing a L7R and L7S may not be a good idea.
- Started by cougakilnem09
- Wiring, Electrical & Installation
About this thread
Latest topics
-
-
-
-
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1