Xtracab pickup, is rear fill needed?

toneddie

Junior Member
Here is my set up. Alpine CDM-7874, Fosgate 250.2 bridged mono to JL Audio Stealthbox, Infinity Kappa 5 x 7 running off HU, factory tweets in upper door panel off HU.

I have two questions:

1. Should I install a mid-priced component set and add another amplifier then relocate the 5 x 7's to the rear factory locations?

OR

2. Should I add another amp for the Kappas' and the factory tweets and eliminate the rear fill stockers.

I like it loud and clean.

Any suggestions welcomed

David

 
toneddie-add another amp and

get a good set of componet speakers and wire them

to your new amp

move your 5x7 to the rear stock speaker location

( if they fit .) and wire the 5x7 also to the amp

 
i have an extended cab ranger, and i don't have any rear fill. in terms of sound quality, rear fill can be detremental unless you're running a 5.1 processor or something to that effect, which will temper how much the rear speakers will put out. if all you care about is playing it loud, then rear fill is very important. more drivers = more output.... my opinion, of course!

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

toneddie

Junior Member
Thread starter
toneddie
Joined
Location
lodi, ca
Start date
Participants
Who Replied
Replies
2
Views
654
Last reply date
Last reply from
MxRacerCam
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top