WTF it makes no sense -- mids just quit, tweets and subs ok??!??

[skiingsean]

Last night after getting a phone call and turning down the volume to about 1 or 2 I found out that my mids completely quit working. This makes no sense as my tweets work fine and my subs are receiving low line signal.

After turning the volume back up all 4 mids literally just quit working. There's only one speaker cable run to each tweet/mid from the 6030cs set (ie. not a separate run for each tweet and each door speaker).

Any thoughts?

Click to read more...

 

[skiingsean]

Also it doesn't sound like I'm getting any line noise to the mids.. so I'm hoping it's not the Kappa 4 .. but I guess I'm just waiting for someone to say it is :s

 

[nateberrier 10+ year member]

wut

 

[skiingsean]

Hrm sry thought when I signed up and put in my setup into my registration it'd show on my sig.

Setup is a Pioneer DEH-P7200HD, 2x infinity 6030cs's, 2x infinity 1262w's, a kappa 4, and a crappy mb quartz --- No clue what happened but all 4 door mids just kapoot as if all 4 crossovers went **** up at the same time.

 

[nateberrier 10+ year member]

are the speakers amped?

 

[skiingsean]

yes from the kappa 4.

 

[skiingsean]

speakers (tweets + mids) --> Infinity Reference 6030cs 6-3/4" component speaker system — also fit in 6-1/2" openings at Crutchfield.com

 

[Louisiana_CRX 5,000+ posts]

bad crossover

 

[surreal 10+ year member]

Take the xovers out of the equation, test the mids. Do they play or can you get em to pop? Have a meter?

 

[skiingsean]

I have a meter and can take the panels off but it literally doesn't make statistical sense that 4 Xovers went bad at one time. I'll hook a 9v up to them in a bit and write back but I'm sure they will push/pull -- I also need to crank the vol and listen closely as so far i haven't heard any noise from them (again, hoping it's not in the kappa 4). I'll also throw the kappa on LPF and move the subs over to it and see what I get.

I'll write back in a bit.

 

[RAM_Designs 5,000+ posts]

Test with a dmm and then go form there if they actually read right.