Would you use a cap with my setup?

Blazin_Jason
10+ year member

CarAudio.com Elite
Alright I am looking for opinions on whether or not I should use a cap with my setup. I will be running an orion 2500d to 2 12" premier 3000's @ 1 ohm around 1500 watts or more. I plan on running 2 redtops (can't afford yellows) under the hood. I am going to be ordering my wiring soon and am trying to decide which route to go. The wiring will be Stinger HPM series, because I want purple wire (Get over it).

1. My orginal idea was to run dual runs of 1/0 from the batteries back to the amp into these reducers.

reducers.jpg


There is some space in between them all, but I will grind them down some more for a little extra clearance. Also I would be putting heat shrink over the reducers.

2. If the reducer idea doesn't plan out I could either trim 1/0 to fit, or just run dual runs of 4 gauge.

3. I have a Lanzar 5 farad cap from before I started taking car audio more seriously. If I did that I would probably just go with a single run of 1/0 to the cap then 4 gauge to the amp.

So I'm looking for opinions on what some people would do and why. Thanks

Jason

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Blazin_Jason

10+ year member
CarAudio.com Elite
Thread starter
Blazin_Jason
Joined
Location
Vancouver Isl, BC, Canada
Start date
Participants
Who Replied
Replies
9
Views
732
Last reply date
Last reply from
Fate710
IMG_20260513_214311575.jpg

ThxOne

    May 13, 2026
  • 0
  • 0
IMG_20260513_213956814.jpg

ThxOne

    May 13, 2026
  • 0
  • 0

New threads

Top