trunolimit
Junior Member
Hello every one. I am a complete noob so I was hoping I could get some advice from people who know their stuff. I've been doing some research and I've put together 2 systems That I think would work in my Honda civic 2005 ex coupe. one system has one big sub while the other has 2 smaller subs.
first system
2 Kicker 07TCVT12-4 ****SUB
* Sensitivity: 98 dB
* RMS Power Range : 400 Watts
* Peak Power Handling: 800 Watts
* Impedance: 4 Ohm
* Low Frequency response: 25 Hz
* High Frequency Response: 500 Hz
* Diameter: 12 Inch
Kicker 08ZX700.5 ****AMP
* 5-Channel ZX Series Amplifier
* RMS Power @ 4 Ohms: 70W x 4 + 210W x 1
* RMS Power @ 2 Ohms: 85W x 4 + 420W x 1
* RMS Power Bridged @ 2 Ohms: 130W x 2 + 420W x 1
* Selectable High/Low/Full Pass filters
* 50Hz - 200Hz Crossover with 24dB
* Signal to noise: 95dB
Alpine SPS-600 *****FRONT DOOR SPEAKERS
# Sensitivity: 88 dB
# RMS Power Range : 80 Watts
# Peak Power Handling: 240 Watts
# Impedance: 4 Ohm
# Frequency response: 70-22000 Hz
# Diameter: 6.5 Inch
# Design: 2 Way
I also have a 2 farad capacitor and an installation kit. Total cost is $817
second system would be
1 Kicker 08VS12L72 ****SUB
* Sensitivity: 89 dB
* RMS Power Range : 750 Watts
* Peak Power Handling: 1500 Watts
* Impedance: 2 Ohm
* Low Frequency response: 20 Hz
* High Frequency Response: 100 Hz
* Diameter: 12 Inch
Soundstream PCA1000D *****AMP
* Peak Power Output: 2000 watts approx.
* RMS Power Ratings:
o 500 Watts x 1 Channel @ 4 Ohms
o 800 Watts x 1 Channel @ 2 Ohms
o 1000 Watts x 1 Channel @ 1 Ohm
* Min. Impedance Unbridged: 1 ohm
* THD @ Rated RMS Power: 0.5%
* Speaker Level Inputs: No
* Amp Preamp Outputs: 1 Pair
* Built-in Crossover: LP (50 - 150 Hz), Subsonic (15 - 40 Hz)
* Bass Boost: 0 - 18 dB
* Signal-to-Noise Ratio: 80 dB
* Fuse Rating: 30A x 3
* Continuously Variable Low-Pass Crossover: 50 - 150 Hz (24 dB/Oct.)
* Continuously Variable Subsonic Filter: 15 - 40 Hz (24 dB/Oct.)
* Variable Subwoofer Equalizer: 0 - 18 dB
* Phase Control: 0° / 180°
* Frequency Response: 5 - 250 Hz
* Adjustable Input Sensitivity: 0.5 - 4V
* Damping Factor: >200
* Fully Regulated MOSFET Power Supply
* PWM Circuitry
Alpine SPS-600 *****FRONT DOOR SPEAKER
# Sensitivity: 88 dB
# RMS Power Range : 80 Watts
# Peak Power Handling: 240 Watts
# Impedance: 4 Ohm
# Frequency response: 70-22000 Hz
# Diameter: 6.5 Inch
# Design: 2 Way
in order to drive the alpines above I would install a second amp
SoundStorm F2.200 ******AMP DRIVING DOOR SPEAKERS
* Max Power @ 2 Ohm: 100W x 2
* RMS Power @ 4 Ohm: 50W x 2
* Signal-To-Noise Ratio: 90dB
* THD at RMS Output: 0.01%
* Damping Factor: 125+
* Dimensions: 9"W x 2-1/16"H x 5-1/8"L
* Low Pass Crossover (Fixed, 120 Hz)
* Variable Input Gain Control
* Line and Speaker Level Inputs
* Frequency Response: 12Hz - 22kHz (+/- 3 dB)
with the installation kit and the 2 farad capacitor this system comes out to $894
I would appreciate any and all advice you guys have for me. my budget is 1000 dollars so if you guys have an even better sound system for this budget please feel free to let me know and if you think these amps are wrong for these speakers let me know also. Thanks
first system
2 Kicker 07TCVT12-4 ****SUB
* Sensitivity: 98 dB
* RMS Power Range : 400 Watts
* Peak Power Handling: 800 Watts
* Impedance: 4 Ohm
* Low Frequency response: 25 Hz
* High Frequency Response: 500 Hz
* Diameter: 12 Inch
Kicker 08ZX700.5 ****AMP
* 5-Channel ZX Series Amplifier
* RMS Power @ 4 Ohms: 70W x 4 + 210W x 1
* RMS Power @ 2 Ohms: 85W x 4 + 420W x 1
* RMS Power Bridged @ 2 Ohms: 130W x 2 + 420W x 1
* Selectable High/Low/Full Pass filters
* 50Hz - 200Hz Crossover with 24dB
* Signal to noise: 95dB
Alpine SPS-600 *****FRONT DOOR SPEAKERS
# Sensitivity: 88 dB
# RMS Power Range : 80 Watts
# Peak Power Handling: 240 Watts
# Impedance: 4 Ohm
# Frequency response: 70-22000 Hz
# Diameter: 6.5 Inch
# Design: 2 Way
I also have a 2 farad capacitor and an installation kit. Total cost is $817
second system would be
1 Kicker 08VS12L72 ****SUB
* Sensitivity: 89 dB
* RMS Power Range : 750 Watts
* Peak Power Handling: 1500 Watts
* Impedance: 2 Ohm
* Low Frequency response: 20 Hz
* High Frequency Response: 100 Hz
* Diameter: 12 Inch
Soundstream PCA1000D *****AMP
* Peak Power Output: 2000 watts approx.
* RMS Power Ratings:
o 500 Watts x 1 Channel @ 4 Ohms
o 800 Watts x 1 Channel @ 2 Ohms
o 1000 Watts x 1 Channel @ 1 Ohm
* Min. Impedance Unbridged: 1 ohm
* THD @ Rated RMS Power: 0.5%
* Speaker Level Inputs: No
* Amp Preamp Outputs: 1 Pair
* Built-in Crossover: LP (50 - 150 Hz), Subsonic (15 - 40 Hz)
* Bass Boost: 0 - 18 dB
* Signal-to-Noise Ratio: 80 dB
* Fuse Rating: 30A x 3
* Continuously Variable Low-Pass Crossover: 50 - 150 Hz (24 dB/Oct.)
* Continuously Variable Subsonic Filter: 15 - 40 Hz (24 dB/Oct.)
* Variable Subwoofer Equalizer: 0 - 18 dB
* Phase Control: 0° / 180°
* Frequency Response: 5 - 250 Hz
* Adjustable Input Sensitivity: 0.5 - 4V
* Damping Factor: >200
* Fully Regulated MOSFET Power Supply
* PWM Circuitry
Alpine SPS-600 *****FRONT DOOR SPEAKER
# Sensitivity: 88 dB
# RMS Power Range : 80 Watts
# Peak Power Handling: 240 Watts
# Impedance: 4 Ohm
# Frequency response: 70-22000 Hz
# Diameter: 6.5 Inch
# Design: 2 Way
in order to drive the alpines above I would install a second amp
SoundStorm F2.200 ******AMP DRIVING DOOR SPEAKERS
* Max Power @ 2 Ohm: 100W x 2
* RMS Power @ 4 Ohm: 50W x 2
* Signal-To-Noise Ratio: 90dB
* THD at RMS Output: 0.01%
* Damping Factor: 125+
* Dimensions: 9"W x 2-1/16"H x 5-1/8"L
* Low Pass Crossover (Fixed, 120 Hz)
* Variable Input Gain Control
* Line and Speaker Level Inputs
* Frequency Response: 12Hz - 22kHz (+/- 3 dB)
with the installation kit and the 2 farad capacitor this system comes out to $894
I would appreciate any and all advice you guys have for me. my budget is 1000 dollars so if you guys have an even better sound system for this budget please feel free to let me know and if you think these amps are wrong for these speakers let me know also. Thanks
