Where to put da Powahh???

[Why So Cereal? 5,000+ posts]

I dont feel like im givin my comps up front enough power. Theyre only gettin about 40-50 rms (unless my amp is underrated). My amp is bridgeable down to 2 ohms, so i was thinking of bridging my amp to my highs then getting some efficient coaxials in rear and running them off HU power. (equipment is in my sig)

would this be a good idea? or should i just try and get a stronger 4 channel and add more power all around. I like to have my rear fill so completely unhooking is not an option.

amp specs:

RMS Power Rating @ 14.4VDC:

60 watts x 4 chan. @ 4 Ohms

100 watts x 4 chan. @ 2 Ohms

Bridged:

200 watts x 2 chan. @ 4 Ohms

245 watts x 2 chan. @ 2 Ohms

RMS Power Rating @ 12.6VDC:

45 watts x 4 chan. @ 4 Ohms

75 watts x 4 chan. @ 2 Ohms

Bridged:

145 watts x 2 chan. @ 4 Ohms

200 watts x 2 chan. @ 2 Ohms

Click to read more...

 

[Why So Cereal? 5,000+ posts]

bump...noticed they seem to distort around 400hz and below...why? lack of power? doors need to be deadened? baffles needed?

 

[hispls 5,000+ posts]

Bridge your 4 channel to the fronts. If you absolutely must use "rear fill" without any time delay or processing HU power is more than enough to **** up your phasing and imaging.