Sidebar

when I hook up my amp the subs keep fading in and out. I checked for crossed wires bu

Reply
  • 2
    Participant count
  • Participant list
Jump to latest
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Previous thread Next thread

Similar threads

William Melcic
Im trying to hook up a 4 channel amp
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
530
General Car Audio
1aespinoza
1
M
Hook up amp & sub , amp don’t power on
Got it , LOC black wire actually needed to be grounded . Every video I watched said said it doesn’t and that’s just to reduce noise but apparently...
12
2K
General Car Audio
mmouse223
M
J
Amp power wire hook up.
If you have multiple amps you do not need to run a power wire from each amp to battery.. You can have a single run of wire with a distribution...
1
1K
Amplifiers
deez283
deez283
B
Amp and remote wires issue amp wont power on unless i hook up the poer wire half on power other half on the remote plug whats wrong
Your amp 12v+ is usually a thick wire, same thickness as your ground wire. The remote input is a thin wire that is usually connected to a wire...
4
1K
Wiring, Electrical & Installation
some dude
some dude
C
Amp hook-up advice
I like Alpine for low power stuff.
6
1K
Wiring, Electrical & Installation
metalheadjoe
metalheadjoe

About this thread

M

mde2

Junior Member
Thread starter
mde2
Joined
Location
akron,ohio
Start date
Participants
Who Replied
Replies
1
Views
785
Last reply date
Last reply from
BASSBOY
Share thread
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top
Menu
Home
Refresh