What to set my amp's Low Pass Filter and Subsonic Filter to?

  • 3
    Participant count
  • Participant list

trenthonda1
10+ year member

Member
113
0
Florida
I have a Skar Audio SK-1500.1D wired down to 1 ohm on a Fi Audio BL 15'' in a ported box 3.25cf. I need help setting the the Low Pass Filter and the Subsonic. Here are the specs, Low Pass Filter @24dB Slope : 35~250Hz, Subsonic Filter @24dB Slope : 10~50Hz And if it helps i mostly listen to hip hop/rap. Right now idk whats its set to but when i turn the sub up it sounds like the sub is bottoming out?

 

---------- Post added at 10:30 AM ---------- Previous post was at 10:29 AM ----------

 

Oh and the Phase Shift???

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
154
Hello all. Used to come on these forum quite a bit. I used to compete in IASCA MECA etc. and placed 1st 2x with this setup. Anyway this is my baby...
0
708
Voltage for the signal? What does that mean? Electricity isn't measured in purpose. Gain is a characteristic of a circuit. You aren't adjusting...
20
6K
Sundown SIA1250. You can wire it to one or two ohms and get the same power. Don't wire it to ½ ohm.
2
1K
Time alignment is used to delay every speaker closer than the furthest to have the sound hit the listeners ears at exactly the right time. If this...
8
653

About this thread

trenthonda1

10+ year member
Member
Thread starter
trenthonda1
Joined
Location
Florida
Start date
Participants
Who Replied
Replies
7
Views
19,492
Last reply date
Last reply from
Below20hzonly
20240519_201344.jpg

audiobaun

    May 19, 2024
  • 0
  • 0
Screenshot_20240519-213549.png

1aespinoza

    May 19, 2024
  • 0
  • 0

New threads

Top