what sub setup??

Propel152

Junior Member
Ok, currently I have one kicker CVR 10" sub in my crew cab truck. It is in a downfire enclosure. I recently upgraded my mids and highs and the sub is now lacking. It doesn't exist in the same presence as it did before. I need a little more bass to compensate for louder mids and highs. This is where my dilemma is.. Space is very limited so I'm trying to avoid dual subs. That would leave me with less cubic feet of volume for each sub. With one and I can I have more space for a bigger box. I have two Kicker CVX 10" sitting in my floor that I could use. I hear the CVX's are a drastic improvement over the CVR's Just wondering if one sub with a larger box that is closer to spec requirements for cubic feet would be better than cramming to subs with not much room or space to perform.

 
crew cab Silverado 1500. I have passengers so it will have to be a downfire box under rear seat. Which limits space for sub drastically. One thing I don't understand is that JL audio, and Alpine don't require or recommend near the amount of sealed cubic feet volume as kicker??

 
Yeah, kicker need big boxes to perform. You would be much better off with one sub in the proper size as opposed to trying two and choking them-not enough room to perform as intended.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

My bad, yes, I read them each as having two 4ohm coils. The JBL diagram left a bit to be desired, IMO. ;) And a double yes, thought U was talking...
9
1K
My bad I thought that for some reason you were selling them for 450 apiece. That's why I was so confused why you would sell them for that price.
10
1K
Sure we need to grow up, ok. I gave you the exact answer then you blew up on me saying I was wrong. Time for self reflection bud. Cant take...
20
3K
That would be a function of the harness, not the HU, I think. Have you looked into a Maestro or iData interface? i would check with crutchfield...
12
468

About this thread

Propel152

Junior Member
Thread starter
Propel152
Joined
Location
southaven,MS
Start date
Participants
Who Replied
Replies
3
Views
710
Last reply date
Last reply from
macsdad
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0

New threads

Top