BassAddictJ 5,000+ posts
CarAudio.com Veteran
I'm thinking about running my kx 2500.1 at a .35ohm dcr load hoping for imp rise to bring me around 1ohm or 2ohms or so for daily bumping. I will have a solid electrical (250amp alty and a d3100 next to the amp). I've taken off the cover and will be replacing the top with clear plastic. I plan on mounting a large fan blowing onto the board and leaving a gap(s) at the other end(s) of the clear plastic to where the hot air will push out. I'm wondering if i should place the fan closer to the power input side, middle, or signal input side, or if itll make any differance at all, or will i just blow my amp?
im hoping with a steady 14.4v and a **** load of air to keep it cool maybe i can pull this .35ohm dcr off daily. i've run kx 2500.1's at .7ohm dcr at 12v really hard for up to 40min with no additional cooling modifications...got hot but never blew.
thoughts?
im hoping with a steady 14.4v and a **** load of air to keep it cool maybe i can pull this .35ohm dcr off daily. i've run kx 2500.1's at .7ohm dcr at 12v really hard for up to 40min with no additional cooling modifications...got hot but never blew.
thoughts?