Type R

Lucid15
10+ year member

Always open to trades!
So i am going to be beginning a project for an enclosure for my 10" Type R with my Grandpa, who is an expert with wood (40+ years experience). Anyways, i want to make a custom enclosure that will accept my rear strut bar in my car as well, like an indent on the top or something, also a custom mitsubishi cutout emblem on the top of the box and paint it glossy red and the box black. question is, i want to go ported what freq and size of box should i make for this 10" Type R.. I need suggestions! im feeding it about 750 RMS.

 
your box wont hit your strut bar unless its designed to lol that bar behind the seats is exactly under the strut take a look at it again. i had the same thoughts until i really looked at it.

 
I am purchasing an aftermarket rear strut bar to connect the two rear struts. I believe the box will interfer. What should i tune my box to for that R?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Lucid15

10+ year member
Always open to trades!
Thread starter
Lucid15
Joined
Location
Portland,OR
Start date
Participants
Who Replied
Replies
15
Views
1,161
Last reply date
Last reply from
adio25
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0
IMG_2118.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top