Two 15 inch strokers...what happened......video inside

I dont get it //content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif
you dont HAVE to set your gains with a DMM, but if you dont you should be very conservative and keep them low.... being no where near or > than half.

 
you dont HAVE to set your gains with a DMM, but if you dont you should be very conservative and keep them low.... being no where near or > than half.
says who?

His subs are rated at what.....2000rms at piece and he only has a 2600watt overrated amp on them....id say a bit over half is conservative enough for that particular setup

 
says who?
His subs are rated at what.....2000rms at piece and he only has a 2600watt overrated amp on them....id say a bit over half is conservative enough for that particular setup
//content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gif

does his deck only output a volt or 2?//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif

 
//content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gif
does his deck only output a volt or 2?//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif
Who knows....either way...safe

Considering everything else is in tip top shape

 
Yeah the only thing i could think also would be clipping, because there is no way that amp would blow those subs, unless the strokers are very over ratted??
not sure if theyre overrated but i know they cant take a 4kw on each coil for a burp:cool:

 
i dont know u shouldnt be able to fry those in twenty minutes no matter what unless it was something extreme

ive ran cheaper speakers not having any idea what i was doing on there full power and they played for atleast months

did u have the speakers wired correctly

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

crownvicdriver

10+ year member
Member
Thread starter
crownvicdriver
Joined
Location
Huntsville, AL
Start date
Participants
Who Replied
Replies
91
Views
6,271
Last reply date
Last reply from
moh.vze.com
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top