- Thread Starter
- #16
I must have still had the meter still in ohms or something, I just went out to doublecheck and set to 10 ac v (using a very cheap meter) I was getting near no power at all.
-
5Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
- Started by .........
- The Lounge
And I moved my underhood fuse block to be harder to see 🤣
- Started by spokey9
- Amplifiers 2
I'd probably start by making sure the connector at the back of the HU is tight.
Hi all,
In the process of adding a sub and new speakers to my 5th gen RAM. In terms of what happened, I installed a 2x10 sub and it's running...
- Started by ThumpNoThump
- Wiring, Electrical & Installation
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
About this thread
New threads
-
WANTED Down4Sound MM1004 GrayWould like a gray D4S MM1004 to match my other gray MM1004...
- Started by kenvicta
- Replies: 0
-
What's this worth?Going to go on a different direction when I get my new...- Started by chillin
- Replies: 2
-
-
Multi speakersHello all, need some wiring advise for some speakers. I have...- Started by 07FLSTC
- Replies: 2
-
Yamaha Ypa-700!Scored this on ebay. Listed as untested. They accepted my...- Started by metalheadjoe
- Replies: 1