DC lvl 4's //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif And no vids yet //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif...will definitely get on that when I can find my camera or someones around with one.vids? Have you decided on the 10s yet? edit nevermind I saw the FIs
This has been said a lot //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif check out the guts //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.giflooks like an american bass 1100.1. it must be 20k at 18volts.
I wonder if that's EXACTLY like the DD Z-SE? //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
You're right. The Audioque is around 8 inches longer than the Z-SE.I saw a guy holding the new DD and it didnt look as big...
O ok. I have been debating on just cutting up some of the mdf I have left or glassing it. It's where the front part of the box connects to the rear, and the way it's set up following the floor makes it a funky angle...I figured since I have access to the mat that is used to make the hulls of boats, maybe I'll put it to use. Or maybe just HD mat if they're out. I was thinking about layering it until it is about an inch to an inch and a half thick. The spots are only about 5"x37".Thanks. And I have it layered up pretty well, its solid. I'll have to watch it closely on some low notes to see if it flexes any though...not very much at all if it is