subwoofers Xsite

[joen]

Good afternoon my name is Jorge and I am of Ecuador, I write this mensaja to him to do consultations and hope to him can help me.

I have two subwoofers of the Xsite mark model xs1285 with the next specifications:

bajos Xsite 12" 1000 watts RMS

modelo xs1285

12" ultra high excursion site spl subwoofer

99oz. massive bouble stacked strontium magnet

power handling: 1000 watts R.M.S.

frequency response: 30 hz - 500 hz

efficiency: 92.5 dB

3" aluminiunvoice coil former

Fs (Hz) 36.3

Qms 7.5

Qes 0.854

qts 0.767

Vas (liters) 56.5

Vas (cubic feet) 2

EBP 42.5

Revc (2 each @) Ohms 3.6

SPL (1w-1m)dB 92.5

Xmax (mm) lineat peak-peak 10

caja cellada minima (pies cubicos) 0.75

caja cellada maxima (pies cubicos) 1.5

caja ventilada (pies cubicos) 2

3dB down point (Hz) 32.85

Vented to (Hz) 36

port Dimensions 4 x 9.25"

and my restlessness is, whereupon amplifying I must connect them… I have three options:

1. - Xsite xad2k

1 x 2000W @ 1 ohm

THD: 0.05%

S/N Ratio: >100dB

Freq. Response: 25Hz ∼ 200Hz

Dimensions: 17.71" x 10" x 2.17" (45cm x 25.4cm x 5.5cm)

Class D Circuitry

2000 Watts @ 1 Ohm

Multi-Stranded Power

Supply Toroids

Blue Anodized Heat Sink WIth

Lazer Diamond Surface

Brushed Aluminum Case

Remote Bass Control

THD:0.05%

S/N Ratio>100dB

Variable Sub Sonic Filter: 15Hz-40Hz

Variable Phase Shift: 0-180°

Variable Bass Boost Control:0-18dB

Frequency Response:25Hz-200Hz

Tiffany-Style Input & Output RCA Jacks

Milspec Double-Sided Epoxy Circuit Board

Data Link Port (Combines 2 Amplifiers Into a Single Output)

2. - Xsite xsd1200

Class D Circuitry

1200 Watts @ 2 Ohm

Multi-Stranded Power

Supply Toroids

Blue Anodized Heat Sink WIth

Lazer Diamond Surface

Brushed Aluminum Case

Remote Bass Control

THD:0.05%

S/N Ratio>100dB

Variable Sub Sonic Filter: 15Hz-40Hz

Variable Phase Shift: 0-180°

Variable Bass Boost Control:0-18dB

Frequency Response:25Hz-200Hz

Tiffany-Style Input & Output RCA Jacks

Milspec Double-Sided Epoxy Circuit Board

Data Link Port (Combines 2 Amplifiers Into a Single Output)

3. - Fusion FP 1000 D

1 Ohm / 2 Ohm Stable Linked

CEA 2006 Amplifier Power Standard Compliant

FUSION Regulated Amplifier Technology (F.R.A.T)

FUSION Intercooled Semi-conductor Technology (F.I.S.T)

FUTRANZ Efficient Heat Sink Transfer Technology

Gold Plated 4 gauge Power and Ground Connections

Gold Plated Audio Input and Output Connections

Gold Plated RCA Output for Multi-purpose installations

Compatible with FUSION bass control remote

Product Specifications

Bandwidth 10Hz - 250kHz

Signal to Noise >95dB

Fuse Rating 3 x 30A

Separation >60dB

Input Sensitivity 300mV-8V

LP Variable Crossover 40 Hz - 240Hz @ 24 dB / octave

Variable Bass Boost 0dB + - 12dB Gain @ 45 Hz

Variable Sub Sonic Filter 10 Hz - 50Hz

Input Impedance 20K

Damping Factor >200

T.H.D 0.05%

Dimensions D 57.5mm L 220mm H 220mm

CEA 2006 Compliant Amplifier Ratings

12.6 Volt Power Output Specifications

450 WRMS per Channel @ 4 Ohms and 1% THD+N

725 WRMS per Channel @ 2 Ohms and 1% THD+N

1050 WRMS Bridged Channels @ 4 Ohms and 1% THD+N

14.4 Volt Power Output Specifications

575 WRMS per Channel @ 4 Ohms and 1% THD+N

1000 WRMS per Channel @ 2 Ohms and 1% THD+N

1400 WRMS Bridged Channels @ 4 Ohms and 1% THD+N

Linked Power Ratings @ 14.4VDC

1650 Watts RMS Linked @ 4 Ohms

2550 Watts RMS Linked @ 2 Ohms

I hope and desire you can respond to me of the way but it makes specific and fast… on purpose you can help me with the measurement of the box for both low, I want a box model bass reflex…

Beforehand express my gratefulness and will wait for your message

Click to read more...

 

[Immacomputer 10+ year member]

The first amp would be your best bet.

That sub does not seem like it will work out well in a bass reflex enclosure. It has very little motor strength and will more than likely sound very muddy.

 

[Toxic Tuan 10+ year member]

According to those specs...they're audiobahn identical. Which means: get the fusion amp.

tuan

 

[snoopdan 5,000+ posts]

yeah Ive got a couple of xsite amps sitting around here, they're pretty much Audiobahn equipment. From me just popping the top on them and looking at the motherboard, they dont appear to be too badly designed.

 

[southernking1]

i've had to xsites 12's. i bust one of them. they sound ok thou

 

[ThatChevyGuy 5,000+ posts]

be very careful on the amount of power you give the subs, i had two of those same in the fifteens and had them on 500 each and they blew, they sounded absolutely horrible too. Hopefully yours dont.