DJ Eric P. 10+ year member
Member
Ok I have a Kenwood KX600.4 4ch amp which is rated at:
75x4 @ 4 ohms
150x4 @ 2 ohms
300x2 @ 4 ohms
I also hav 2 12" Audiobahn AW1200Q's which are 4 ohm DVC's
Now since I can't get the 4 ohms out of each speaker do I wire each coil to a channel, just wire them up @ 2 ohms and only get 150 watts to each sub or just buy a new ****ing amp.
LMK what you guys think on how I should wire theses bastards. They are currently wired at 8 ohms and sound like ****. Also would I kill the amp if I wired the subs at a 2 ohm load and then bridge the amp?
75x4 @ 4 ohms
150x4 @ 2 ohms
300x2 @ 4 ohms
I also hav 2 12" Audiobahn AW1200Q's which are 4 ohm DVC's
Now since I can't get the 4 ohms out of each speaker do I wire each coil to a channel, just wire them up @ 2 ohms and only get 150 watts to each sub or just buy a new ****ing amp.
LMK what you guys think on how I should wire theses bastards. They are currently wired at 8 ohms and sound like ****. Also would I kill the amp if I wired the subs at a 2 ohm load and then bridge the amp?