Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Sub/Amp wiring dilemma.......HELP!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="DJ Eric P." data-source="post: 658487" data-attributes="member: 555823"><p>Ok I have a Kenwood KX600.4 4ch amp which is rated at:</p><p></p><p>75x4 @ 4 ohms</p><p></p><p>150x4 @ 2 ohms</p><p></p><p>300x2 @ 4 ohms</p><p></p><p>I also hav 2 12" Audiobahn AW1200Q's which are 4 ohm DVC's</p><p></p><p>Now since I can't get the 4 ohms out of each speaker do I wire each coil to a channel, just wire them up @ 2 ohms and only get 150 watts to each sub or just buy a new ****ing amp.</p><p></p><p>LMK what you guys think on how I should wire theses bastards. They are currently wired at 8 ohms and sound like shit. Also would I kill the amp if I wired the subs at a 2 ohm load and then bridge the amp?</p></blockquote><p></p>
[QUOTE="DJ Eric P., post: 658487, member: 555823"] Ok I have a Kenwood KX600.4 4ch amp which is rated at: 75x4 @ 4 ohms 150x4 @ 2 ohms 300x2 @ 4 ohms I also hav 2 12" Audiobahn AW1200Q's which are 4 ohm DVC's Now since I can't get the 4 ohms out of each speaker do I wire each coil to a channel, just wire them up @ 2 ohms and only get 150 watts to each sub or just buy a new ****ing amp. LMK what you guys think on how I should wire theses bastards. They are currently wired at 8 ohms and sound like shit. Also would I kill the amp if I wired the subs at a 2 ohm load and then bridge the amp? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Sub/Amp wiring dilemma.......HELP!
Top
Menu
What's new
Forum list
