should i install my edead?

[ActionJ-01-Z71 10+ year member]

i got me edead this week and am wanting to put it on. its been cold so i havent. tomorrow the high is 54. think i should try to do it or wait till it gets a little warmer than in the 50s?

Click to read more...

 

[jjski78 10+ year member]

I'd wait til it hit at least 60, but that's just me.

 

[btlking 10+ year member]

do it we are having some installed and its like 30 below outside 50s should be fine

 

[el_chupo_ 10+ year member]

I recently did the floor of my jeep with the high of about 55. It ******. It took a bit with a powerful hair dryer, and even then I wouldnt have done it on anything vertical.

I would wait, or get a big halogen lamp that puts off a lot of heat, and heat up the edead and area before you do it.

Matt

 

[Supergumby5000 5,000+ posts]

is it cement or rubber butyl stuff? i had edeads v1^2 butyl stuff, and did it when there was snow on the ground. No issues during install, and its stickin strong.

 

[bdawson72 5,000+ posts]

I had some rammat and wondered the same question

 

[Chevyaudio 5,000+ posts]

I hate applying deadener...

And I hate it even more in cold.

 

[ActionJ-01-Z71 10+ year member]

just got done putting it on the trunk lid and still have tons left. plan on putting the rest on the inside trunk panels, floor and rear deck.

i could not believe the difference it made. i would put a little bit on, shut the trunk put on some pumps and get out to see the difference. amazing!!!