Repaired speaker making fuzzing noise on low frequencies

  • 2
    Participant count
  • Participant list

kirsty

Junior Member
It is quite faint, and only noticeable if the speaker is isolated, my only concern is, is the buzzing the speaker re-tearing, or is it just natural for a repair job. In other words, if I put the door panel on and properly install the speaker, is it just going to get worse until it finally blows up?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

dragon.breath, Many thanks for taking the time to help me out. It is very much appreciated and my small brain can understand it now. I have...
6
120
Drill a hole and use the proper protective split loom and hole grommets to keep the outer speaker jacket from knicks and cuts, give just enough...
8
724
I'd be willing to pay for a quality HU, if it meant that I can truly get the sound quality I need. I've seen some aftermarket ones that look...
10
740
You could do the 8" as a front sub on its own amp and use it to bridge/enhance the gap between your 12" in the rear to the midranges
6
564

About this thread

kirsty

Junior Member
Thread starter
kirsty
Joined
Location
Australia
Start date
Participants
Who Replied
Replies
2
Views
778
Last reply date
Last reply from
kirsty
IMG_0632.jpg

just call me KeV

    Apr 19, 2024
  • 0
  • 0
IMG_0629.jpg

just call me KeV

    Apr 19, 2024
  • 0
  • 0

Latest topics

Top