My trunk has a solid amount so sdsd cld and mlv all around on bottom and lid
The point is how much stuff is between the trunk and the cabin (seats/metal/panels/etc.)?
So what would be the best option, I have a back seat that I never noticed rattle from. But my speaker pods on the rear deck are made of cheap plastic and they rattle a bit, I put CCf on the bottom of them but they don't bolt down well
Have you ever heard two 15s in a trunk? Cut a little metal on the back deck if necessary. Turn the entire trunk into a box. 1 or 2k on two 15s in a sedan is pretty dang loud.
Im actually doing two big 18s walled in an 02 mustang. They were correct when they said its a commitment plus its a lot of planning and work. Not to mention the weight it will put on a suspension, and thats more money gone to compensate. Honestly if you arent wanting to make it a literal car audio project I probably wouldnt recommend a wall. Thats just my opinion though
Total weight of birch wouldnt be too bad though expensive.
It would be pretty genius, I bet it would be completely unique as well.
Would need room for amps/ bats though and with no trunk. Might be hard to make it look clean and might put one out of certain spl classes.
As tempting as this is, I think my car is pretty nice and I wouldn't want to make my first spl build innit.. maybe if I get into a house with a garage I'll go further in. I don't really even want to build an enclosure in my trunk for the simple fact that I don't want to have to saw it out when I sell the car and make a huge mess. How can I do that cleanly? Because you do have me thinking about possibly doing a high end SSA or FI 18
An 18 in a trunk just isnt going to happen. You might be able to get away with 15s with a small amount of trunk opening (into cabin) cutting. Could most likely get 12s in there. If you don't want a mess. Cover everything on the inside of the trunk with paint catcher. Its just a big plastic sheet painters use. Then build the box. When you cut it out. You wont have saw dust in the carpet and such.
I'm not intending to hit 160s, and i planned on a ridiculous amount of deadening anyways.. I just want to get stupid low.if I were to build in trunk you don't think I could pull off an 18? I was thinking maybe 2 Q 15s or 2 icon 15s.. if I'm going big I'm gonna have to do a good bit of deadening and get an extra batt so I'd rather stick with 3.5k as long as I can. I know I could pull 2 12s because I had a ZCON enclosure built by cscstang that was 6.5 ext and it cleanly slid in and out of my trunk. I'm not sure on exact dimensions though which is kinda sucky on my part. But I figured 6 external cubes, if I did an external aeroport and sub firing up, I could pull at least 5.5 net volume doing the same enclosure. I would just need to brace it well. I just don't want to spend more than 700 on subs.
The way I see it. The trunk should be for the box and whatever the size of your opening from your trunk to your cabin is the max size of your sub.
I have 300a singer alt and 2 agm a, big 3 and all. Upgrading to big 5 and another two runs of 0awg to the trunk when I find a nice deal on some wire. And my seats don't fold down, that is a major issue I'm assuming.. I don't really intend on taking the seats out permanently either.
