prepurchase questions for powering an infinity kappa 100.3

aesthetik

Junior Member
I currently have a stock wrx stereo and it's terrible so i'm replacing it with a kdcbt752hd (decent or awful?). I plan on hooking up a single 10" infinity kappa 100.3. I'm considering an alpine mrpm500 but the 4ohm rms is 300w and the spec range on this sub is 50-275 w/ 1100 peak. Is this too much amp or not enough? Could $200 be better spent on something else? I'll admit i have no idea what i'm doing and any advice or insight would be greatly appreciated!

Thanks in advance - aesthetik

 
what is it that you want out of your system?

what do you plan on adding?

and last of all whats your TOTAL budget?

 

---------- Post added at 12:01 AM ---------- Previous post was at 12:01 AM ----------

 

what is it that you want out of your system?

what do you plan on adding?

and last of all whats your TOTAL budget?

 
I just want it to be louder without blowing the stock speakers with some bump in the trunk. I don't need crazy loud or top notch, i just wanna get the bass out of the door speakers and in the trunk. I have about 400 total to spend and do have a big sheet of mdf i can fab something out of as well..

So total my plans are to install the deck and run an amp and sealed 10 in the trunk for now. I may decide to add tweeters and upgrade the speakers somewhwere down the road but thats another project and budget..

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

aesthetik

Junior Member
Thread starter
aesthetik
Joined
Location
boise,id
Start date
Participants
Who Replied
Replies
2
Views
590
Last reply date
Last reply from
aesthetik
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top