Old PPI upgrade

  • 1
    Participant count
  • Participant list

SpankeyND
10+ year member

Junior Member
I recently aquired a PPI 2150M, but the stock wires coming out of it ****. I don't like splicing, and the speaker wires are anemic. Where can I find a distribution block, screw type like on the newer amps so I can just run my speaker wire to it? Is this going to be hard to wire on the inside? Will this improve anything if I improve the guage on these wires?

Thanks

Richard

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

There is the 16pin connector in armrest of my old mercedes 2006 S350. Any possible way I can stream music from my phone wirelessly(Bluetooth) or...
0
565
Not all 3 have same issue. Was just giving an example of the issues Each one has its own issue Yes I did replace rca cables and swapped left and...
3
1K
The dirtiest hooker allive gotta smell better than fried Epoxy! (okay, that was a tad bit nasty, but funny nonetheless!)
8
1K

About this thread

SpankeyND

10+ year member
Junior Member
Thread starter
SpankeyND
Joined
Location
Nordakoda
Start date
Participants
Who Replied
Replies
0
Views
426
Last reply date
Last reply from
SpankeyND
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top