New truck build - completely clueless. Need suggestions

  • 1
    Participant count
  • Participant list

caseyboy43

Junior Member
Planning on getting PHD FB 6.1 KIT PRO for the front stage and the PHD MF6.1C for the coaxial.

Have JL 300/4 and want to add a second JL 300/4 to provide drivers with enough power (instead of running larger 4 or 5 channel amp).

JL 500/1 powering four (4) JL 6W0 in ported box

Unsure of HU. Want double din w/ built in Nav as I l don't like wires hanging around.

 
Last edited by a moderator:
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

ok i get it dodge ram and full strip inside for second skin . power is run down drivers side and speaker wire is run down passanger side thank you
2
1K
front doors are subs...fyi Go with AudioControl 6x9 components up front and coaxials in the rear. You will be impressed with just changing to that.
4
419
Absolutely. I am always learning and think it's probably impossible to stop learning. I appreciate the advice and don't doubt for a second the...
56
4K
A lot of guys say I'm going low-end on cost but I see a lot of guys recommending just as cheap or cheaper products. Like MESO-6-5-3WAY-COM //...
13
2K
Then I would get the dual 4 ohm subwoofers and wire it to 1 ohm like in the link below. Those subwoofers are 500 watts rms so running them at 1...
8
2K

About this thread

caseyboy43

Junior Member
Thread starter
caseyboy43
Joined
Location
New Jersey
Start date
Participants
Who Replied
Replies
0
Views
473
Last reply date
Last reply from
caseyboy43
Screenshot_20240518-030709~2.png

1aespinoza

    May 18, 2024
  • 0
  • 0
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top