ok, given the box shape in the pic with the notch for the seat bracket. If I were to run 2 subs, 8's or 10's. or multiple 8's, where would I port the box? My new dimensions for a wedge or triangular shaped enclosure are 51" wide, height up front would be 5.75", height in rear would be 3", top panel 19" deep, and bottom panel 17.5" deep. I would of course add the
2 1/4x12x15 additions under each sub(like shown in the pic) around the center hump. Total gross volume would be 1.667cuft.
Due to the box shape, since I would be running multiple subs, the only viable option would be to port on the front of the box. But then, the height would be sloping down. I could I guess stop way short of the back wall and extend out in both directions of the subs in a t shape.
To get max volume, I don't think there is any way to avoid building around the notch. If I did, and didnt run the box as deep, then I would only have room for (1) 10 ported. This would then probably put me back to running 4-6 6.5's or a sealed enclosure. Clear as mud? Thoughts?
bottom of current box with addition for depth